![]() ![]() Even during playback there were glitches. So far it'll actually be stable, but it has big latency, so I lowered buffers for BOTH devices (enable the advanced settings in the ASIO panel and click on each device and lower the buffer individually) to 256 samples. In ASIO4ALL settings panel enable both devicesĤ. install the necessary drivers and utility software on your computer. ![]() But it will not recognize it as a sound card through settings. When Ive tried to install the drivers, my laptop will both recognize the unit as a tascam 800 and an 1800. In Reaper request 48000 Hz sampling rate.ģ. 2 Installation (Windows 2000 and Windows XP). I see Tascam has made drivers for this device that go as far up as windows 7, and theoretically it they should work with windows 10, which which run now. this change for sure allowed me to use the WASAPI driver when both the Behringer and TASCAM interfaces are enabled, but I wanted to use the ASIO driver because I can use both devices as inputs sometimes if needed).Ģ. I have also tried this on a version of windows 10 which is supposed to be (win 10 v.1903) with the same result. ![]() I am not sure if Windows Settings affects the ASIO4ALL (btw. I have a Tascam UX-1800 and when plugged into my windows 10 pc it say it has malfunctioned and I am unable to install the drivers on it. I set the Behringer in Windows Settings to also use 48KHz. Both devices must have the same sampling rates and it seems this has to be 48Khz because that's all the TASCAM reports as supported. I spent about 15 hours trying to debug this and I think that finally I found a configuration that hasn't crashed so far and has usable latency when recording.ġ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |